Chemicals Store/MetalForce
TS-610 Master Code100% GB-CLP Verified
TS-610UK Stock Ready for Despatch
MetalForce Phosphoric Cleaner & Descaler
Standard Dilution1:50 to 1:100
Heated Reaction50°C–90°C Optimized
Substrate SafetyPaint & Alloy Safe
Phosphoric Acid Rust Wash

MetalForce Phosphoric Cleaner & Descaler

Phosphoric acid metal wash that removes light surface rust, cleans weld scale, and phosphatises steel.

Select Pack Format:SKU: ALK-CHM-TS610-20L
Trade Price
£118.00ex VAT
1
Formulation

Clean deeper. In less time.

Standard detergents rely on superficial foam. Alkota master chemistry attacks the static bond holding road film, grease, and exhaust soot to paint and metal.

When high-pressure water alone hits road film or engine grease, it shears off the loose top layer while leaving behind a dull static film.

MetalForce Phosphoric Cleaner & Descaler is built around the original TS-610 formula. Developed alongside industrial pressure washers, it uses heat-stable surfactants that break down grease and suspend dirt in the rinse stream before it can re-settle.

Hot Water SynergyAccelerates from 50°C to 90°C without evaporating active agents.
Coil SafeNon-crystallising formula protects heating coils and pump seals.
UK CompliantFully registered with verified UK Safety Data Sheets.

Surface Action

1. Penetrates the Film

Lowers water surface tension to get beneath road dirt and traffic grime.

2. Breaks Down Oils

Turns heavy petroleum oils and diesel exhaust soot into water-soluble emulsion.

3. Clean Rinse

Holds dirt suspended so it washes away completely without streaking.

Target Soils

The dirt it dissolves.

Formulated specifically to dissolve stubborn environmental residues, baked soot, and oily binders that resist ordinary wash soap.

01

Road film & diesel exhaust soot

02

Heavy machinery grease & hydraulic oil

03

Winter road salt & de-icer chlorides

04

Atmospheric soot & industrial fallout

05

Baked brake dust & transmission fluids

Application Protocol

Three steps to a clean surface.

Follow this application sequence to maximise chemical cleaning efficiency and prevent waste.

STEP 01

Dilute & Meter

1:10 to 1:25 with clean water.

Set downstream injector or foam lance metering valve to match water hardness and soil density.

STEP 02

Apply & Dwell

Apply via brush or low-pressure spray

Apply evenly from bottom to top to prevent run lines. Allow 2–3 minutes contact dwell without letting it dry.

STEP 03

High-Pressure Rinse

150–200 Bar pressure rinse with 50°C–65°C hot water

Rinse thoroughly from top to bottom. Surfaces will sheet freely with zero chalky detergent residue.

Safety:Causes skin irritation and serious eye irritation.
SDS PDF →
Technical Specification

Substrate & Safety Dossier.

Verified surface interactions under standard operating dilution, formulation profile, and downloadable GB-CLP documentation.

Substrate Compatibility Matrix

Structural Steel & Cast Iron
recommended
Stainless Steel
recommended
Formulation Reference
Master Code:TS-610
Original Name:Phos Clean
Family:MetalForce
Compliance:100% GB-CLP Verified
Induction:High/Low Pressure Injector
Safety Documentation

Safety Data Sheet (SDS)

Official UK CLP safety dossier for TS-610 covering active composition, PPE requirements, first aid protocols, and storage.

Master Formula TS-610 (Phos Clean)
Sourced, Stocked & Despatched from Alkota UK